|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Search this Thread||Display Modes|
Setting up AFR Tracking on the GEN II (Turbo Buicks)
Once your wbo2 is set up and verified to be accurate you can configure the tracking feature in the AFR Tracking page.
Providing you are running a Extender G Chip, here is how it works.
The first three options are low limit settings. Once the mininum tps, rpm and load limits are met, afr tracking kicks in. Here are the settings I suggest to start with.
min tps 3.000
min rpm 3200
min load 166.4
lean lim % 10.0
rich lim %25.0
afr 10.8 from 2000-8000
af trdelay 0.3
From there set up the sensor monitor page to read AFR Des (Desired Air Fuel Ratio) and WB Corr (Wideband Fuel Correction). This is the page you want on when your out driving. When wb correction is triggered the AFR Des will appear and the WB Corr will show how much fuel is being added or subtracted.
Add or subtract fuel in the Tune High page to get WB Corr close to 0.
Generally the tune should be dialed in close before tracking is enabled.
**87 Buick GN**
109 block steel crank/mains
Ported Irons roller cam/rockers
Ported intake/acufab plenum PT front mount
70GTQBB 83lb injectors Razor alky
Maf Translator pro/LC-1 WB
Last edited by Rick87gn : 04-04-2011 at 05:39 PM.
|Thread Tools||Search this Thread|