![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
![]() |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
![]() Bob,
I just have one quick question about how the wires connect to the brake switch. In the diagram it looks as if the 2 wires from the harness are twisted together and then connected to one side of the switch and then the other side goes to a 12v source. Am i looking at this correctly, or does each wire go to a separate post on the switch? Thanks! |
#2
|
|||
|
|||
![]() you have it correct
|
#3
|
|||
|
|||
![]() So on a switch with 3 "post", I only use 2?
|
#4
|
|||
|
|||
![]() yes.
"C" and "NO" Bob |
#5
|
|||
|
|||
![]() Ok, thanks a bunch!
|
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|