|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-26-2012, 08:16 PM
|
|||
|
|||
Hello all.
Hello from the Dallas Texas area. I'm here in search of knowledge about Turbo Buicks and to contribute however I can. I owned a 87 GN back in 96. It had a custom cam, chip, injectors, turbo, downpipe, intercooler, exhaust, fuel pump, a bad tune and no diagnostic hardware like we have today. I was 19, in college,low on money and just didn't have access to the knowledge needed to solve the cars tune problems. Ended up selling it.
 Well, my brother has recently bought a 86 Turbo Buick with a moderate setup. It also has a few problems to start out. BUT, it has a MAF Translator and Scanmaster. Hopefully with a bit of research and maybe some experienced guidence from here we'll be able to sort it out and get it on the road. I'll try and post a picture of it up this weekend.
|
|
#3
10-28-2012, 08:32 AM
|
||||
|
||||
|
Welcome, and nice T !! We'll try and help out as much as we can!! Information is always king!! Always provide as much info as possible when relating info on a problem.
Again, welcome.
__________________
TurboDave EWCS(SW) USN (Ret.) (1965-1988) Email us Sevierville, TN TranslatorPro MAFless fuel, spark, boost and fuel pump management Now using SD2 system. 86 GN(TranlatorPro/ExtenderPro on speed density w/boost and fuel pump control,PLX-WB) 87 GN(stock, for show) 01 Excursion LTD 7.3L PSD(Power Stroke Diesel), Turbo, 4X2 (big puller) 12 Lincoln MKT, 3.5V6 Twin Turbo Ecoboost 365HP (driver)
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
