![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
![]() |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
||||
|
||||
![]() This is instructions for Tuner Pro
__________________
When the student is ready, The teacher will appear |
#2
|
|||
|
|||
![]() Hey Mike, I can't find the spark table on the .doc Is there another pages with it on there? Thanks!
__________________
Donnie 1987 Grand National 10.873 @ 124.107mph Translator Pro, Pro Chip, LC1 WB, 30 over 109 block, std turbo crank, polished stock rods, Sealed Power Forged Pistons, Race ported and polished Irons, Champion Intake, 83's, CompCams 210/210 ductile roller, Roller Lifters, 1.65 Roller Rockers, 70mm tb with Polished PTE Plenum, CPT70 P Trim .82 ar housing, 3" THDP, 2¾" Dual Exhaust w/ Welded Ultra Flo Race Magnums, PTE FMIC, TA Performance SS Headers, ARP bolts and studs. |
#3
|
|||
|
|||
![]() try this
|
#4
|
|||
|
|||
![]() Quote:
Thanks Bob, I guess that was why I was having a hard time trying to figure out what volt was what, didn't have table to go by. The .doc you sent to me the an email was the same way but now I have seen the light!! errrr, the table ![]()
__________________
Donnie 1987 Grand National 10.873 @ 124.107mph Translator Pro, Pro Chip, LC1 WB, 30 over 109 block, std turbo crank, polished stock rods, Sealed Power Forged Pistons, Race ported and polished Irons, Champion Intake, 83's, CompCams 210/210 ductile roller, Roller Lifters, 1.65 Roller Rockers, 70mm tb with Polished PTE Plenum, CPT70 P Trim .82 ar housing, 3" THDP, 2¾" Dual Exhaust w/ Welded Ultra Flo Race Magnums, PTE FMIC, TA Performance SS Headers, ARP bolts and studs. |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|